favorite
favorite
hide
unhide
flag

Posted

print

DIY Bluetooth 5.0 Stereo Audio Receiver Module - $5 (Leesburg, Florida)

DIY Bluetooth 5.0 Stereo Audio Receiver Module 1 thumbnailDIY Bluetooth 5.0 Stereo Audio Receiver Module 2 thumbnailDIY Bluetooth 5.0 Stereo Audio Receiver Module 3 thumbnailDIY Bluetooth 5.0 Stereo Audio Receiver Module 4 thumbnailDIY Bluetooth 5.0 Stereo Audio Receiver Module 5 thumbnailDIY Bluetooth 5.0 Stereo Audio Receiver Module 6 thumbnail
Located in Leesburg, Florida, in the Pennbrooke Fairways gated community.
(The map location shown here is accurate).

Leesburg is between Orlando and Ocala, and quite close to The Villages.

This is one new Bluetooth 5.0 receiver.

It is powered by a USB-C port (use your charger and cable), or you can solder a 5V DC power source to the pads on the board.

The analog stereo line-level output is through a 3.5mm (1/8") stereo phone jack (a mini headphone connector).
Alternately, you can solder wires to the three line-level audio output pads on the board (Left Channel, Right Channel and Common/Ground).

This is a VERY small board, only 1.18" square!

You can use this board to convert almost ANY audio amplifier, receiver or amplified speakers to receive Bluetooth Audio!

Thanks!
Darron

post id: 7747770413

posted:

updated:

best of [?]

loading
reading
writing
saving
searching